Audiovox Car Security System APS 996a Spezifikationen PDF herunterladen (Seite 9)

Grey Wire: Hardtop Close Actuator (DB 25 Pin 13)

The D48 connector is located under the control switch garnish. Find pin 11 on

the connector. It will have 12V applied when the hardtop switch is operated to

the close position. Although the manual states this wire is Blue / White I found it

to be Light Blue in my car.

Clear Wire: +12V Ign2 Output (DB 25 Pin 14)

The D48 connector is located under the control switch garnish. Find pin 4 on the

connector. It will have 12V applied when the key is turned to the “On” position.

WIFI TOP

™

Module Location

The best locations for the interface module are under the rocker switches or

behind the ECU. To install the interface module you will need to loosen the trim

piece that holds the rocker switches in the center console. The interface module

at 2.6 x 4.25 x 1.12 is small enough to slip into the open slot. You can zip tie it to

the wire harness or use double-sided tape as you prefer. Simply plug the module

into the Interface harness making sure it is fully seated.

Audiovox APS-996a Specific Programming

This section is specific to my installation and programming of the remote control.

These are the key combinations I programmed into the APS-996a channels.

APS-996a Channel Remote Key Combination Function

1 “Lock” Lock

2 “Unlock” Unlock

3 “Key” Tonneau Open

4 ---- ----

5 “Key” + “Lock” Hardtop Close

6 “Option” Tonneau Close

7 “Key” + “Unlock” Hardtop Open

Table 4 - APS-996a Specific Programming

Troubleshooting the Installation

There are 5 LEDs to assist diagnosing problems with the installation; however

they are not viewable unless the case is opened. The LEDs indicate the active

timing cycle(s).

D2 = Tonneau Open LED

D4 = Tonneau Close LED

D6 = Hardtop Open LED

JNS Engineering 9 3/28/2009

D11 = Hardtop Close LED

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 30 31

Keine Kommentare

Audiovox Car Security System APS 996a Spezifikationen Seite 9