Audiovox Car Security System APS 996a Spezifikationen PDF herunterladen (Seite 12)

Remote Start Neutral Safety Switch

First a disclaimer. Installing a remote start capability in a manual transmission

car is not safe, probably voids the security system warranty, and is possibly

against the law. The author takes no responsibility for any consequences from

the correct or incorrect use of the following information.

Now with that out of the way the author recognizes that many people might be

installing remote start into their MTX 3000GT without hooking up any safety

devices to prevent accidental start while in gear. This instruction, if followed

correctly, will provide an additional measure of safety for remote starting.

Benefits

 Prevents remote starting with the car in gear

 Prevents manual starting in gear with the clutch out

 Uses the stock starter disable circuits so it works with any alarm setup

Parts Needed

 Magnetic switch

o Normally open type (continuity when the magnet is close)

o Recessed mount type (cylindrical type allows perpendicular mount)

o AMS-21 or equivalent is suggested (about $2 at this site)

o Go here for a datasheet for the part

 Relay

o Standard automotive type (about $1.50) (Note that if you

purchased the APS-996a alarm you should have an unused relay)

o Go Here for a primer on relays

 Other stuff

o I used RTV and a tie wrap to secure the magnet and switch

o I used T-Taps to connect to existing stock wiring

Stock locations for stuff

 Theft Alarm Starter Relay C56

o This is mounted on the driver’s side of the center console under the

carpet. It is the relay closer to the shifter. Not sure if this is

standard on all versions of the car.

 Ignition wire C59 Pin 5

o Black/Yellow wire to the left of the steering column

JNS Engineering 12 3/28/2009

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 30 31

Keine Kommentare

Audiovox Car Security System APS 996a Spezifikationen Seite 12