
Remote Start Safety Tests
Push in the clutch and attempt to start the car in any gear. It should fail to
start.
Turn the Red toggle switch OFF. Attempt to Remote Start the car. It
should fail to start.
Remote Start the car. Touch the brake pedal. It should shut down.
Remote Start the car. Rev the accelerator. It should shut down.
Remote Start the car. Pull the hood latch. It should shut down.
If any of these tests fail, consult the manual and check the wiring immediately.
How to Read the 3000GT Wiring Diagrams
Each included page from the 3000GT electrical manual shows a relevant
connector number at the bottom of the page as well as information somewhere in
the body of the page regarding signals in that connector. For example, the MFI
circuit page is included to show the Parking Lights wire information. This wire is
G-W (green white) and can be found at C-69 pin 6. On the bottom of the
diagram you can find the connector number and a symbol showing that 8 pins
are present on this connector. I highlight pin 6 here:
C69-6
1234
5678
This particular wire is one of the tougher ones to locate. C69 is part of the
junction block next to the driver’s left foot. Look for the 8 pin connector with a
green white wire on pin 6.
3000GT Specific Wiring diagrams
The following pages are excerpted from the 3000GT shop manual. Use the
configuration diagrams to find the appropriate connector locations. Consult the
manual for further detail.
JNS Engineering 18 3/28/2009
Kommentare zu diesen Handbüchern