Audiovox Car Security System APS 996a Spezifikationen PDF herunterladen (Seite 10)

D16 = System LED

There are also Test points for each input trigger and ground. These are labeled

as follows:

TP1 = Tonneau Open Trigger

TP2 = Hardtop Close Trigger

TP3 = Tonneau Close Trigger

TP4 = Hardtop Open Trigger

TP5 = Ground

The installation can be tested independently from the car alarm system by

manually triggering the timer circuits. To cause a timing cycle to begin, simply

make a momentary connection between the appropriate trigger test point and the

ground test point. The system will respond by lighting the appropriate LED and

driving the top mechanism.

When any of the four TPs is triggered, the system timer will power the car as

though the ignition switch were in the ON position. All electrical systems (such

as Climate Control and Radio) that were running when the car was last turned off

will resume operating until the system timer expires.

Remote Top Testing

Key sequences

 Press and hold “KEY” button for 4 seconds. The tonneau should open.

 Press the “OPTION” button. The tonneau should close.

 Hold the “KEY” button and then press the “UNLOCK” button. The hardtop

should open.

 Hold the “KEY” button and then press the “LOCK” button. The hardtop

should close. If the hardtop fails to complete closure after the safety stop

or spends an excessive time in the safety position, follow the adjustment

procedure for the closure timer.

 Press the “KEY” button twice within 3 seconds. The car should remote

start (if equipped). All key sequences listed above will function under

Remote Start as well as battery power only.

JNS Engineering 10 3/28/2009

The Remote Top Key Sequences WILL NOT initiate any actions if the car is

running normally after being started by the key.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 30 31

Keine Kommentare

Audiovox Car Security System APS 996a Spezifikationen Seite 10