Audiovox APS-997C Installationshandbuch PDF herunterladen (Seite 21)

128-8775b

21 of 32

REMOTE START OVERRIDE MODE / MANUAL SHUT DOWN:

The intent of the remote start override / manual shut down circuit is to allow the vehicle operator to prevent

operation of the Remote Start Unit regardless of the RF transmitter operation.

To Enter The Remote Start Override Mode:

1) With the system disarmed/unlocked, and the ignition switch off Press and Hold the pushbutton switch

located on the receiver unit on.

2) Turn the ignition switch on, off, on, off, on, off.

3) The LED begins to flash two short flashes followed by one long flashes and continues this pattern until

returned to normal mode of operation.

The action above puts the unit into the Remote Start Override mode or vehicle service mode and will not

start from the RF transmitter or any other input.

To Exit Remote Start Override Mode:

1) With the system disarmed, Press and Hold the PBLED on.

2) Turn the ignition switch on, off, on, off, on, off.

3) The LED turns off indicating that the R/S unit is fully functional one again.

DO NOT RELEASE THIS VEHICLE TO THE CONSUMER UNTIL YOU CONFIRM THE

OPERATION OF THE MANUAL SHUT DOWN / ENABLE FEATURE.

NEUTRAL START SAFETY TEST:

The intent of the neutral start switch is to prevent the vehicle from starting while the gear selector is in any

position other than Park, or Neutral. When installing a Remote Start Device, it is imperative that the Yellow

Starter wire be connected to the ignition switch side of the Neutral Start Switch. Consideration for the

placement of a starter inhibit relay is important as well and should be connected to the ignition switch side

of the Yellow Start Wire.

To test the integrity of the Neutral Start Safety Circuit:

1) Set the vehicle parking brake.

2) Block the drive wheels to prevent vehicle movement.

3) Temporarily disconnect the Brown/Black positive shut down wire from the vehicle's brake switch.

4) Sitting in the vehicle, start the engine using the vehicle's ignition key.

5) Step on the brake pedal and shift the gear selector into reverse.

6) Allow the transmission to shift. When you feel the engine pull, do not move the gear selector just turn

the ignition switch off. DO NOT attempt to remove the key.

7) Keeping the brake pedal depressed, activate the RF transmitter in an attempt to start the vehicle. The

car should not start.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Keine Kommentare

Audiovox APS-997C Installationshandbuch Seite 21