Audiovox APS-997C Installationshandbuch PDF herunterladen (Seite 20)

128-8775b

20 of 32

Multi Coil Pack Adaptor: (Optional)

The multi coil pack adapter, is designed for use with vehicles that do not respond to single coil tach

programming. Although the tach resolution of this circuit is designed to interface direct with most vehicles,

there may be an occasion where the following circuit may be required. Construct the adaptor as shown

below.

To use the adaptor, the Green/Black wires must connect to the negative side of the ignition coil(s).

1. For vehicles utilizing independent coils per cylinder, connect the three Green/Black leads to alternate

coils. To achieve optimum performance the coil signals must be evenly distributed. This is accom-

plished by first mapping out the firing order of the engine in groups of as indicated below. Draw a circle

around any of the columns. The Green/Black wires should be connected to the negative (-) terminal of

the respective cylinder number which appears in any of the circles.

2. For vehicles utilizing 2 cylinder firing per coil pack, connect Green/Black to the tach side of each coil

pack. For 8 cylinder, four coil systems, connect to any of the three coils.

3. Connect the Yellow wire to a +12 volt ignition 1 source. This wire will have +12 volts with the ignition in

the on and start position and have 0 volts with the ignition in the off position.

4. Connect the Green wire to the (Green) or (Orange/Green) tach input of the Audiovox remote start unit.

TESTING YOUR INSTALLATION:

WARNING!! The following procedure must be performed after the installation of any Remote Start Device.

It is the responsibility of the installing technician to complete these tests. Failure to test the unit in the

following manner may result in personal injury, property damage, or both.

HOOD PIN SAFETY SHUT DOWN:

The intent of the hood pin safety shut down is to prevent the Remote Start unit from being activated while a

mechanic or vehicle owner is performing normal routine vehicle maintenance.

To test the integrity of this circuit:

1. With the drivers window in the down position, start the vehicle using the RF transmitter.

2. Reach inside the car and pull the hood release.

3. Raise the hood and confirm that the remote start unit shuts down.

If the unit fails this test, recheck your pin switch connection to the Gray/Black wire of the Remote Start Unit.

DO NOT RELEASE THIS VEHICLE TO THE CONSUMER UNTIL YOU CONFIRM THE

OPERATION OF THE HOOD PIN SAFETY SHUT DOWN FEATURE.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Keine Kommentare

Audiovox APS-997C Installationshandbuch Seite 20