
128-6629
2 of 8
-2-
Pre-Installation Notes:
Receiver Channels and Functions:
Channel 1 is the Lock and Programming select channel of the receiver. This will allow locking of the doors, arming of
the system, if the optional starter inhibit relay is installed and feature selections when in the programming mode.
Channel 2 is the Unlock drivers, and Unlock all doors channel of the receiver. When the transmitter button programmed
into this channel is pressed once, the on-board door unlock relay activates, when the button is pressed a second time,
the 2nd unlock output activates.
Note: Anytime the system is unlocked, the on-board interior illumination relay becomes active for 30 seconds, or until
the ignition is turned on.
Channel 3 allows access to the on-board "Trunk Release Relay". Press and hold the programmed transmitter button
for 3 seconds.
NOTE: An alternate output, (Blue/Black) is accessed when the same transmitter button is pressed and released 2
times within 3 seconds (double pressed). This output is typically used for a remote start option and will likely
prevent inadvertent activation of the remote start device if young children are playing with the hand held
transmitter.
Channel 4 allows access to the negative pulsed or switched output, Green/Black. Press and release the programmed
transmitter button for a 1 second output, press and hold the transmitter button for extended output.
Parking Light Flasher Output:
This system provides an output to control an optional parking light flasher relay (not included).
When this option is installed, the vehicles parking lamps will flash during arm and disarm, as well the output will flash
when car finder mode is activated.
This is a ground (300 mA maximum) output, therefore, a relay must be used to take advantage of this feature.
Horn Output:
This system provides an output to operate the vehicle's horn relay to annunciate arm/disarm/programming and when
used the car finder mode. This low current output is to be used to operate a existing horn relay only. If the vehicle does
not have a horn relay, one will have to be added as the output is capable of 300 mA maximum. The duration of the output
is adjustable (see feature #6), and can be selected off by turning the ignition on then off, then press and release the
program switch 3 times. If the horn was on, it will be turned off, if the horn was off, it will be turned on.
Starter Disable Output:
This system provides an output to control an optional starter cut relay (not included).
When this option is installed, any time the system is locked, the vehicle's starting circuit is inoperable.
Remote Entry Illumination:
This system provides an on-board relay that will operate the vehicle interior light for 30 seconds whenever the system
is disarmed. This circuit will also operate to provide feedback during the transmitter and feature programming modes.
Since both the NO and COMMON relay contacts are wired through the harness, this feature can be used with both positive and
negative switched dome light circuits.
Note: If the accessory lock option is selected on, the interior illumination circuit MUST be connected in order to prevent accidental
locking of the doors. In this situation, the Green/White wire connects to the door pin switch, sensing when the door is opened.
The doors will not lock when the ignition is turned on if the door is opened. This safety feature prevents the operator from
reaching into the car, starting it, then closing the door. If this circuit was not connected, the doors would lock and the operator
would be stuck outside the vehicle with the engine running.
Since both the NO and COMMON relay contacts are wired through the harness, this feature can be used with both positive and
negative switched dome light circuits.
Kommentare zu diesen Handbüchern