Audiovox PRO 9644aUGH Bedienungsanleitung PDF herunterladen (Seite 10)

1. 8 PIN MAIN HARNESS

BLACK - Chassis Ground Source (-)

Connect the BLACK wire to a solid chassis ground point using a ring terminal and self tapping screw (not

supplied). Scrape away paint from the grounding point to ensure a good connection. The recommended

grounding point is a metal surface in the driver’s side kick panel area.

Note: Do not ground the BLACK wire with any other vehicle components.

YELLOW - 12 Volts Ignition Input (+)

Locate the vehicle’s ignition wire at the ignition switch.

Verification: This wire registers voltage when the key is turned to the ON (or RUN) position.

The voltage

does not drop out when the key is turned to the START (or CRANK) position.

Connect the YELLOW wire to the vehicle’s Ignition wire.

PURPLE - Positive Door Input (+)

Locate the vehicle’s dome light or door pin switch wire.

Verification: This wire will register positive voltage (POS) when the door is opened and the interior light is on.

This wire will register ground or "0" Volts when the door is closed and the interior light is off.

Connect the PURPLE wire to the vehicle’s positive door input wire(s).

NOTE: Certain vehicles may require multiple connections. Refer to vehicle application guide

RED/WHITE - 12 Volt Battery Power (+)

Locate 1 of the vehicle’s constant 12 Volt battery wires at the ignition switch.

Verification: This wire will register voltage in all positions of the ignition switch.

Connect the RED/WHITE wire to the constant 12 Volt battery wire.

Note: Remove the in-line fuse until all connections are made.

WHITE - Parking Light Output (+/-) / RED - Parking Light Polarity

Locate the vehicle’s parking light wire at the vehicle light switch.

Verification: This wire will register positive voltage or ground when the vehicle parking light switch is turned

to the ON position.

These wires are the COMMON and NORMALLY OPEN contacts of the on-board parking light relay. If the

vehicle's parking lights are a +12 volt switched system, connect the RED wire to a fused +12 volt battery

source, and connect the WHITE wire to the vehicle's parking light wire. If the vehicle's parking lights are a

chassis ground switched system, connect the RED wire to a chassis ground source, and connect the WHITE

wire to the vehicle's parking light wire.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Keine Kommentare

Audiovox PRO 9644aUGH Bedienungsanleitung Seite 10