Audiovox APS597 - Remote Security System Bedienungshandbuch PDF herunterladen

128-7407A

1 of 12

Model APS-597

Installation Manual

SELECTABLE FEATURES

The selectable features can be set manually as explained below, or with the RF feature programmer.

To set features using the RF programmer, follow the instructions packaged with the programmer.

Factory default settings are indicated by bold text.

Note : The method of manual override can either be selected to operate from the valet switch or operate as custom code.

Be certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.

NOTE: Keyless Entry Models with no horn output will Flash the Parking Lights instead of chirp where chirp is indicated.

Also, No data will be indicated if a feature is not available for a particular model. The unit will enter the feature but no selection will be available.

RF Programmable Feature Bank 1 Is For Transmitter Programming See Transmitter Programming Guide.

RF Programmable Features Bank 2 Is Alarm Selectable Features:

Feature Selection 1 Chirp 2 Chirps 3 Chirps 4 Chirps 5 Chirps 6 Chirps Default

1st DoorL/UL 1 Sec. 3.5 Sec. 1 Sec L, Dbl. U/L Dbl L, 1 Sec UL Dbl L, Dbl UL 1 S l/350mS ul 1S/1S

2nd Accy Lock Accy Lock On Accy Lock Off Auto Locks Off

3rd Accy. UL Accy UL Dr. Accy UL All Accy U/L Off Auto UL Off

4th Headlights On Arm On Disarm On Both Off w/ Arm& Disarm

5th Passive Locks Passive Active Active

6th Pass/Act Arm Passive Arm Active Arm Active

7th Siren/Horn Siren/Horn Siren Only Horn Only Siren/Horn

8th Horn Chirp 10mS 16mS 30mS 40mS 50mS 16mS

9th O/R Method Custom Code Valet Valet

10th 2 Step U/L On Off Off

11th Chp Del Tx On Off Off

12th Volts/HdWire Voltage Sense Hardwire Hardwire

13th Trigger Ckts NA

14th L/UL Poll NA

When using the RF programmer, enter the program mode as follows:

Turn the ignition on

Press and release valet switch 3 times

turn ignition off then on

Press and hold valet switch for 5 seconds

Siren chirps 2 times indicating RF feature program mode.

Note: Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps, or the programming will be terminated.

Rev "a" to add reference to PBLED 7/06

1 2 3 4 5 6 ... 11 12

Inhaltsverzeichnis

Seite 1 - Model APS-597

128-7407A1 of 12Model APS-597Installation ManualSELECTABLE FEATURESThe selectable features can be set manually as explained below, or with the RF feat

Seite 2

128-7407A10 of 12Page 10

Seite 3

128-7407A11 of 12Page 11THIS PAGE LEFT BLANK INTENTIONALLY

Seite 4

Seite 5

128-7407A2 of 12Page 2To program these selectable features;Action System ResponseTurn ignition on No responsePress and release the valet switch 3 tim

Seite 6

128-7407A3 of 12To exit program mode, turn ignition off, or press and release valet switch.RF Programmable Features Bank 3 Is Remote Start Selectable

Seite 7

128-7407A4 of 12Page 4INSTALLATION OF MAJOR COMPONENTSNote: This system allows the transmitter to be programmed for single button lock/unlock or sepa

Seite 8

128-7407A5 of 12Page 5Once a location has been selected, check behind the panel for wire routing access, and to confirm the drillwill not damage any e

Seite 9

128-7407A6 of 12Page 6Connect the dark blue wire to terminal 86 of the AS - 9256 relay (or equivalent 30 A automotive relay), andwire the remaining re

Seite 10 - 10 of 12

128-7407A7 of 12Page 7not start. Audiovox does not recommend using the Orange w/ White trace wire to interruptanything but the starting circuit of the

Seite 11 - 11 of 12

128-7407A8 of 12circuit. In this arrangement, Red, or Green is used to control the drivers door unlock relay, and the Red/Black will be used to contr

Seite 12 - 12 of 12

128-7407A9 of 12factory door lock switch to the factory door lock control relay, you will have to add a relay to invert the outputpolarity of this wir