Audiovox APS787E Installationshandbuch PDF herunterladen (Seite 28)

128-9306

28 of 32

PROGRAMMING BANK 3 (REMOTE START ):

You can enter Bank 3 from Bank 2 by turning the ignition key off then on after you've made the changes

you wanted in Bank 2, (Siren Chirps 3 times), You can also go right to bank 3 by:

1) Turn the ignition key to the on position.

2) Press and release the valet/programming switch 3 times (Siren Chirps Once).

3) Turn the ignition key off then on. (Siren Chirps 2 Times)

4) Turn the ignition key off then on. (Siren Chirps 3 Times)

5) Press the pushbutton switch once to advance to feature 1, twice to advance to feature 2, etc,,,then use

the lock button of the transmitter to select the feature setting.

Example to set engine input check to DBI Tach:

1) Turn the ignition key to the on position.

2) Press and release the valet/programming switch 3 times (Siren Chirps Once)

3) Turn the ignition key off, then on. (2 Chirps)

4) Turn the ignition key off then on. (3 Chirps)

5) Press the pushbutton switch ve times to advance to features 5, Input Check, then use the lock button

of the transmitter to select three chirps, "DBI Tach"

6) To exit the programming mode, turn the ignition key off. Siren sounds a short chirp followed by a long

Chirp.

TACH RATE PROGRAMMING:

1. Turn the ignition key to the On position.

2. Press and release the valet/program push button switch 3 times.

3. Immediately turn the ignition key Off.

4. Press and hold the valet/program push button switch, then start the vehicle using the key.

5. When the unit senses the tach signal, the parking lights will begin to ash.

6. Release the valet/program pushbutton switch. The parking lights will turn on for three seconds to

indicate that the learned tach signal is stored and the unit is out of the tach learn mode.

NOTE: If the unit fails to learn tach rate due to an improper tachometer connection or a poor tach source,

the parking lights will not ash. To correct this situation, locate and connect the Green/Orange wire to

the proper tach signal, and then repeat the tach learn routine.

1 2 ... 23 24 25 26 27 28 29 30 31 32

Keine Kommentare

Audiovox APS787E Installationshandbuch Seite 28