Audiovox APS787E Installationshandbuch PDF herunterladen (Seite 26)

128-9306

26 of 32

The transmitters are pre-programmed from the factory, If you nd you need to program new or additional

transmitters follow the instructions below.

PROGRAMMING BANK 1 (TRANSMITTERS):

1) Turn the ignition key to the on position.

2) Press and release the valet/programming switch 3 times (Siren Chirps Once).

3 Press the Lock Button of each transmitter you want programmed until you hear a chirp from the horn

or siren.

4) Turn the ignition switch off. 1 Short followed by 1 Long Chirp indicates exit of programming mode.

The above action programs the Lock, Unlock, Start/Trunk, and Option 1 buttons of the system. For addi-

tional channel programming see the owners guide found within the literature bag packaged with this kit.

PROGRAMMING BANK 2 (ALARM FEATURES):

You can enter bank 2 from bank 1 by turning the ignition key off then on from step 4 of Bank 1, you will

hear 2 chirps, or You can also go right to bank 2 by:

1) Turn the ignition key to the on position.

2) Press and release the valet/programming switch 3 times (Siren Chirps Once).

3) Turn the ignition key off then on you will hear 2 chirps.

4) Press the pushbutton switch once to advance to feature 1, twice to advance to feature 2, etc,,,then use

the lock button of the transmitter to select the feature setting.

Example to set passive arming:

1) Turn the ignition key to the on position.

2) Press and release the valet/programming switch 3 times (Siren Chirps).

3) Turn the ignition key off, then on, 1Siren chirps 2 times.

4) Press the pushbutton switch six times to advance to features 6, Pass/Act Arm, then use the lock button

of the transmitter to select two chirps "Passive Arm".

5) To exit the programming mode, turn the ignition key off. Siren sounds a short chirp followed by a long

Chirp.

New The chirp and LED patterns have been changed to make it easier to determine what feature you

are in. As well the feature bank will not time out until the ignition switch is off for more than 5 seconds.

The change will ne noted when you get to feature # 11, the LED and chirp pattern will be 1 pause, 1,,#12

will be 1 pause, 2, #13 will be 1 pause 3, #22 will be 2 pause 2, etc. This will reduce noise, and make it

eaised for the installer to determing what feature they are up to.

Feature Bank Reset: If you wish to reset a feature bank to the default settings,,,from within that bank,

press and hold the pushbutton on the receiver/antenna for 5 seconds or until a chirp / ash is heard from

the system. This action resets the feature bank. The feature banks are reset individually so resetting bank

2 will not effect bank 3 & visa versa.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Keine Kommentare

Audiovox APS787E Installationshandbuch Seite 26