Audiovox PRO9776C Installationshandbuch PDF herunterladen (Seite 17)

128-8787b

17 of 32

1 Black: 250mA Output (-)

The black wire switches on when the remote start is activated and will stay on as programmed in the

remote start feature Bank3 Feature 12.

2 Red: 250mA Output (+) 12 Volts Constant

This output is intended to allow the control of a transponder bypass interface module or transponder

bypass relay.

Additional Harnesses And Connectors For The System

4 Pin Upgrade Telematic Module: Connector Port)

Red = + 5 Volts / Black = Ground / White = Data TX / Yellow = Data RX

Connect the 4 pin harness found in the Telematic one way or CArlink II kits to the mating port on the

controlling circuit.

NOTE: If using the TWO WAY Telematic module, only Ground, TX, and RX are used on this port, the + 12

volt supply for the two way module must be sourced separately or the unit will not operate.

5 Wire Antenna/Receiver Program Push-Button Switch/LED Connector: Part # 1123905

Plug the previously routed antenna connector from the antenna receiver assemble into the mating connector

of the control module. This connector supplies 12 volts, ground and RF data input and output, LED cathode,

and Valet Enable to and from the antenna receiver and the remote start module. Be certain this connector

is firmly seated making good contact to the control unit.

4 Pin Shock Sensor: (White Connector) Part # 1122591

The Red (+12 volt), Black (ground), Blue (pre-detect) and Green (full trigger when armed) wires loaded into

the white connector shell are the inputs/outputs of the shock sensor. Route the 4 wire harness from the

shock sensor to the remote start control unit and plug the 4 pin white connector into the mating 4 pin

connector shell of the control module.

NOTE: While operating under the control of the remote start unit the shock sensor will be shunted (by

passed). Once the remote start shuts down, the shock sensor will be re-enabled.

4 PIN IN VEHICLE DATA BUS PORT (DBI Port) (Connector Port)

The 4 pin port located on the side of this module is for proprietary Audiovox data bus interface modules.

These modules are used to access a variety of features in the vehicle which can be as simple as door trigger

inputs, to more complex door locks outputs, or transponder interfaces for remote starting. DO NOT connect

anything to this port other than the Audiovox IDB modules or damage to the Remote Start module will occur.

All installation instructions for the IDB modules will be packaged with the individual component along with

the proper 4 pin wiring harness requires to access the data transmit & receive as well as the proper voltage

levels for the interface.

TIMED START PROGRAM:

The Remote Start unit has the ability to start the vehicle automatically at timed intervals. This feature is

useful in extremely cold climates where starting the engine is the only means to keep the battery charged

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Keine Kommentare

Audiovox PRO9776C Installationshandbuch Seite 17