Audiovox PRO9555 Installationshandbuch

Stöbern Sie online oder laden Sie Installationshandbuch nach Auto Alarmanlage Audiovox PRO9555 herunter. Audiovox PRO9555 Installation manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 16
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
128-6507
1 of 16
Kit Contents
(1) - Control Module
(2) - 3 Button High Frequency Transmitters
(1) - 3 Channel Code Learning Receiver
(1) - Multi Pin Input/Output Harness
(1) - Six Pin Power Harness
(1) - Two Pin I/O Harness Factory Alarm By-Pass and Diesel Wait To Start Input
(1) - 2 Pin Door Lock Harness
(2) - 30 Amp In-line Fuse Holders With Fuses
(1) - Control Switch
(1) - Programming Switch
(1) - Ring Terminal
(4) - 1/2" Long Screws
(1) - Pin Switch
(1) - Remote Start Warning Label
(1) - Literature Package
Model PRO-9555
Installation Manual
3 Channel Remote Start / Keyless Entry System
Installation Instructions
This Unit Is Intended For Installation In Vehicles With
12 Volt Negative Ground Electrical Systems,
Gasoline or Diesel With True Tach Reference
And Automatic Transmissions Only.
Seitenansicht 0
1 2 3 4 5 6 ... 15 16

Inhaltsverzeichnis

Seite 1 - Installation Instructions

128-65071 of 16Kit Contents(1) - Control Module(2) - 3 Button High Frequency Transmitters(1) - 3 Channel Code Learning Receiver(1) - Multi Pin Input/O

Seite 2

128-650710 of 1610Resistive Circuits, As Well As 4 Wire Polarity Reversal and 5 Wire Alternating 12 VoltDoor Lock Control CircuitsThese applications r

Seite 3

128-650711 of 16114. Hold the program switch ON, then start the vehicle using the ignition key.5. When the unit senses the tach signal, the parking

Seite 4

128-650712 of 162. Reach inside the car and pull the hood release.3. Raise the hood and confirm that the remote start unit shuts down.If the unit fail

Seite 5

128-650713 of 16MECHANICAL NEUTRAL SAFETY SWITCH CONSIDERATIONS:Mechanical neutral safety switch configurations differ slightly in that they do not of

Seite 6

128-650714 of 16NOTE: A second 4002 series diode may be required to maintain the integrity of the hood open, shut down circuit. Ifthis is the case, i

Seite 7

128-650715 of 16NOTE: A second 4002 series diode may be required to maintain the integrity of the hood open, shut down circuit. Ifthis is the case, i

Seite 8

128-650716 of 16© 2003 Audiovox Electronics Corp., Hauppauge, NY 11788 1286507

Seite 9

128-65072 of 16This Remote Start/Keyless Entry System is designed for use with Automatic Transmission Vehicles Only! Theunit provides wait to start i

Seite 10 - 10 of 16

128-65073 of 163THE RECEIVER/ANTENNA ASSEMBLY:The Superheterodyne Receiver Antenna Assembly provided with this unit allows routing from below the dash

Seite 11 - 11 of 16

128-65074 of 16NOTE: This wire must be connected to the vehicle side of the starter cut relay (when used). For the electrical neutralswitch configura

Seite 12 - 12 of 16

128-65075 of 16VIOLET WIRE: Accessory OutputConnect this wire to the Accessory wire from the ignition switch. This wire will show + 12 volts when the

Seite 13 - 13 of 16

128-65076 of 16BROWN w/ BLACK Tracer Wire: Positive Inhibit Input 2Any time + 12 Volts is applied to the Brown w/ Black tracer wire, the Remote Starte

Seite 14 - 14 of 16

128-65077 of 16LIGHT BLUE Wire: Ignition 3 / Shock Disable OutputThis wire provides a 300mA ground output that becomes active 3 seconds before the Rem

Seite 15 - 15 of 16

128-65078 of 16Green/Orange Wire: Tach Sensor InputThis wire will continually monitor the engine tach rate while the unit is under power of the Remote

Seite 16 - 16 of 16

128-65079 of 16NOTE: The outputs above are low current outputs and must be used with a relay if the circuit's requirement ismore than 300 mA.2 P

Kommentare zu diesen Handbüchern

Keine Kommentare