Audiovox LCM500NP Betriebsanleitung

LCM500NP 5 Inch Monitorwith2 Video Input CapabilityInstallation and Operation ManualELECTRONICS CORP .®

-8-Controls and Indicators Monitor Panel Controls

-9- Remote Control UnitRemote Control Unit Controls

KEY-10-Remote Control Unit Controls ContinuedKEYPress the to the desired settingPress the to the desired settingPress the MODE key to select thede

Display Mode1. Press MENU to get the On Screen Display (OSD).2. Select FORMAT.3. Press the or the to switch the screen aspect ratio.FULL: 16:

OPERATING INSTRUCTIONS1. POWER ON/OFF/MODEPress the POWER button to turn power on.Pressing the POWER button again momentarily will change video input

MONITOR SPECIFICATIONS1. Type : TFT Active Matrix LCD2. Display Screen Size : 4.3 x 2.5 inches (109.2 x 63.5) (W x H)3. Resolution: 1200 (W) x 234

© Copyright 2001 Audiovox Electronics Corp. 150 Marcus Blvd. Hauppauge, NY 11788 128-6244999.audiovox.comFor Customer Servi

Important NoticeIt is unlawful in most jurisdictions for a person todrive a motor vehicle which is equipped witha television viewer or screen that is

The Materials included in this package:-1-1. LCM500NP Monitor (1pc)2. Remote Control Unit (1pc)3. Interconnection Box (AVX-6865) (1pc)4. Monitor Cable

10) Locate the following: an accessory power source (+12VDC present when the ignition key is in theaccessory and run positions). 0VDC should be presen

-3-Tools and Materials Required:• Utility knife or box cutter with sharp blade• Sharpie™ marker or similar• Tie WrapsRemove the headrest from the vehi

-4-Using your fingers, tear the foam out of theheadrest leaving a recess where the shellwill be inserted.At this point you will need to install thehar

-5-Lay the flaps of headrest material down into therecess and insert the clamshell into the recess.Check for fit. If it does not fit properly, you may

-6-The supplied Release Key is for removing monitor from housing. Refer to the drawing below.MONITOR SURFACE MOUNTING:1. Slide the monitor onto the m

-7-LCM500NP SYSTEM WIRING DIAGRAM1.) Make sure the LCM500NP has been installed properly, as described in the procedures as stated onpages 2, 3, and 5.