Audiovox LCM5043NP Bedienungsanleitung

LCM5043NP & LCM5643NPRemote Controlled Color Display Monitorwith Headphone JackInstallation and Owner's ManualELECTRONICS CORP .®

11) Guide the cable through the sideopening of the Mounting Tray andplug it into the Monitor. Makesure the connector locks intoplace. Insert the Mon

ELECTRICAL CONNECTION (Wiring Diagram)10Video Source Input (1&2)Not UsedAV Output

The following procedure is to remove the Monitor from the MountingTray using the supplied Removal Tool. NOTE: Use care when per-forming this procedur

CONTROLS AND INDICATORSHeadphoneOPERATION1. Press power On/Off button to the On position. The LED powerindicator will light red.2. Press the Picture

MAINTENANCETo avoid electrical shock, do not open the enclosure. High voltageis present. No user serviceable parts inside the enclosure.Do not use any

REMOTE CONTROLLERNOTE: The Remote Controller supplied with this system is a stan-dard remote control, which is used to operate other systems. TheRem

15MENU FUNCTION KEY:The MENU Key is used to navigate between the Color, Brightness andTint adjustment modes. When the MENU Key is pressed an On Screen

16NOTE:For the LCM5643NP - Selecteither *NTSC or PAL, pressthe p or q Keys (CH/DISK/SET).VOLUME CONTROL KEY:To switch between Video Input Sources (AV1

17Replacement of Remote Controller Battery:1. Use a small coin to pry open battery holder from compartment.2. Remove old battery and put in a new one

18LCM5043NP:LCD Panel Size (Diagonal) ... 5"LCD Panel Format ... 9

1EXPLANATION OF GRAPHIC SYMBOLSWARNING:TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD, DO NOT EXPOSETHIS PRODUCT TO RAIN OR MOISTURE.CAUTION:1. This product

© 2002 Audiovox Electronics Corp., Hauppauge, NY 128-6323AUDIOVOX ELECTRONICS CORP. (the Company) warrants to the original retail purchaserof this pr

2SYSTEM OVERVIEWThe LCM5043NP is comprised of a 5" Thin Film Transistor (TFT) Liq-uid Crystal Display ( LCD) Monitor. The LCM5643NP is comprise

MATERIALS LIST1. System Monitor (LCM5043NP=136C2187) or (LCM5643NP=136C2186) (1pc.)2. Remote Control Unit (136B2156) with Lithium Battery, 3V,CR 2025

VEHICLE PREPARATION1) Decide on the system configuration and the options that will be in-stalled (i.e. what components, VCP, DVD, TV Tuner, Video Gam

510) After verifying the proper operation of the system, proceed to mounteach component.11) The mounting method, and the location will vary from vehic

63) Adjust viewing angle of monitor by tightening the fastener at theside.4) When the system components are mounted, test the system toverify that it

71) Remove the headrest from thevehicle for easiest installation.2) Lay headrest on a flat surface.3) Center trim collar on headrestas shown.NOTE: Dep

9) Using your fingers, tear the foamout of the headrest leaving a re-cess where the shell will be in-serted.NOTE: At this point you will need toinst