Audiovox APS-995 Bedienungsanleitung

Model APS 995Installation ManualSELECTABLE FEATURESNote : The method of manual override can either be selected to operate from the valet switch or ope

Orange Wire: Ground When Armed OutputThis wire provides a 300 mA ground output when the alarm circuit is armed to control the starter inhibitrelay.

11Green w/ Orange Trace Wire: Tachometer Input SignalThis wire will continually monitor the engine's tach rate while the unit is under power of t

Dark Blue Wire: Delayed 300mA Pulsed Channel 3 OutputThe Dark Blue wire supplies a 300mA ground pulsed output whenever channel three of the receiver

13should be connected ). Cut the low current starter solenoid wire in the vehicle and connect one side of thecut wire to relay terminal 87. Connect t

14When the unit is selected for output during the start sequence, this output will be active at the sametime Ign. 3 becomes active and will remain act

153 Wire Positive Switched Door Locks:In this application, the Red wire of the door lock harness provides a + 12 volt pulse during the disarmingseque

The Red/Black wire provides a pulse ground output when the unlock button of the transmitter is pressed asecond time after disarming. Connect the Red/

17NOTE: Resistive Circuits, As Well As 4 Wire Polarity Reversal and 5 Wire Alternating 12 VoltDoor Lock Control CircuitsThese applications require th

18TIMED START PROGRAM:The Remote Start unit has the ability to start the vehicle automatically at timed intervals. This feature isuseful in extremely

NOTE: Once you've entered the program mode DO NOT allow more than 15 seconds to pass between steps,or the programming mode will be terminated.Pro

Eighth Press and release the valet switch 1 chirp = siren and horn outputPress transmitter Lock button to change 2 chirps = siren output onlyPress tra

TESTING YOUR INSTALLATION:CAUTION!! The following procedure must be performed after the installation of an Audiovox Remote StartDevice. It is the re

21To test the integrity of the Neutral Start Safety Circuit:1. Set the vehicle parking brake.2. Block the drive wheels to prevent vehicle movement.3

CAUTION!REMEMBER TO RECONNECT THE BROWN/BLACK WIRE TEMPORARILY DISCONNECTED IN STEP 3DO NOT RELEASE THIS VEHICLE TO THE CONSUMER UNTIL YOU CONFIRM THE

23METHOD 2To connect to the key in sensor circuit as shown for method 2:A. Locate the control wire that connects the drivers door pin switch to the ke

this hood switch prevents the remote start activation even if the RF command to start is issued. Thisswitch must be installed in all applications Fa

SHOCK SENSOR:Select a centrally located, solid mounting surface for the shock sensor that will allow consistent opera-tion from all areas of the vehi

YELLOW Wire: Starter OutputCareful consideration for the connection of this wire must be made to prevent the vehicle fromstarting while in gear. Und

WIRING CONNECTIONS: Multi Pin Accessory Input/Output HarnessWhite w/ Red Trace Wire: Parking Light Flasher FeedThis wire is the common contact of the

White w/ Black Trace Wire: (+) Siren OutputThis is the positive siren feed wire. Route this wire through a grommet in the firewall to the sirenlocati

Light Blue Wire: Ignition 3 OutputThis wire provides a 300mA ground output that becomes active 3 seconds before the Remote Start Unitinitializes and

9Green w/ White trace Wire: Entry Illumination Ground OutputThis wire provides a 30 second ground output (300 mA Max.) whenever the remote is used to